Browse

You are looking at 1 - 10 of 1,835 items for :

  • Journal of Applied Biomechanics x
  • Sport and Exercise Science/Kinesiology x
  • Refine by Access: All Content x
Clear All
Restricted access

Volume 40 (2024): Issue 1 (Feb 2024)

Restricted access

Comparison of Concurrent and Asynchronous Running Kinematics and Kinetics From Marker-Based and Markerless Motion Capture Under Varying Clothing Conditions

Robert M. Kanko, Jereme B. Outerleys, Elise K. Laende, W. Scott Selbie, and Kevin J. Deluzio

As markerless motion capture is increasingly used to measure 3-dimensional human pose, it is important to understand how markerless results can be interpreted alongside historical marker-based data and how they are impacted by clothing. We compared concurrent running kinematics and kinetics between marker-based and markerless motion capture, and between 2 markerless clothing conditions. Thirty adults ran on an instrumented treadmill wearing motion capture clothing while concurrent marker-based and markerless data were recorded, and ran a second time wearing athletic clothing (shorts and t-shirt) while markerless data were recorded. Differences calculated between the concurrent signals from both systems, and also between each participant’s mean signals from both asynchronous clothing conditions were summarized across all participants using root mean square differences. Most kinematic and kinetic signals were visually consistent between systems and markerless clothing conditions. Between systems, joint center positions differed by 3 cm or less, sagittal plane joint angles differed by 5° or less, and frontal and transverse plane angles differed by 5° to 10°. Joint moments differed by 0.3 N·m/kg or less between systems. Differences were sensitive to segment coordinate system definitions, highlighting the effects of these definitions when comparing against historical data or other motion capture modalities.

Restricted access

Unrestrained Versus Vertically Restrained Loaded Countermovement Jumps: Are There Any Differences in the Components of Force Application?

Marcos Gutiérrez-Dávila, Daniel Marcos-Frutos, Carmen Gutiérrez-Cruz, and Amador García-Ramos

The objective of this study was to compare a number of variables derived from the vertical and horizontal force components between loaded countermovement jumps performed in a Smith machine (SM modality; vertically restrained jumps) and with free weights (FW modality; unrestrained jumps). Twenty-three recreationally trained individuals, 6 women and 17 men, performed on a 3D force platform 5 maximal countermovement jump trials against 3 external loads (30%, 50%, and 70% of the SM 1-repetition maximum) using the SM and FW jumping modalities on separate sessions. The SM modality promoted greater values for virtually all the variables derived from the vertical force component (maximal force, maximal and minimum velocity, and impulse) and also shorter durations of the braking and propulsive phases. Regardless of the countermovement jump phase (braking or propulsive), the impulse directed toward the backward direction was always considerably greater for the SM compared with the FW modality. These results evidence that for recreationally trained individuals, the SM modality could be more effective to increase the general force capacity of the leg muscles due to increased external stability, while the FW modality is preferable when the orientation of force application is a crucial consideration, as it reduces the horizontal force component.

Restricted access

Alternative Models for Pelvic Marker Occlusion in Cycling

Alberto Galindo-Martínez, Juan Miguel Vallés-González, Alejandro López-Valenciano, and Jose L.L. Elvira

Bike fitting aims to optimize riders’ positions to improve their performance and reduce the risk of injury. To calculate joint angles, the location of the joint centers of the lower limbs needs to be identified. However, one of the greatest difficulties is the location of the hip joint center due to the frequent occlusion of the anterior superior iliac spine markers. Therefore, the objective of this study was to validate a biomechanical model adapted to cycling (modified pelvic model, MPM), based on the traditional pelvic model (TPM) with an additional lateral technical marker placed on the iliac crests. MPM was also compared with a widely used model in cycling, trochanter model (TM). Thirty-one recreational cyclists pedaled on a roller bike while the movement was captured with a 7-camera VICON system. The position of the hip joint center and knee angle were calculated and compared with the TPM continuously (along 10 pedaling cycles) and discreetly at 90° and 180° crank positions. No significant differences were found in the position of the hip joint center or in the knee flexion/extension angle between the TPM and the MPM. However, there are differences between TPM and TM (variations between 4.1° and 6.9° in favor of the TM at 90° and 180°; P < .001). Bland–Altman graphs comparing the models show an average difference or bias close to 0° (limits of agreement [0.2 to −8.5]) between TPM and MPM in both lower limbs and a mean difference of between −4° and −7° (limits of agreement [−0.6 to −13.2]) when comparing TPM and TM. Given the results, the new cycling pelvic model has proven to be valid compared with the TPM when performing bike fitting studies, with the advantage that the occluded markers are avoided. Despite its simplicity, the TM presents measurement errors that may be relevant when making diagnoses, which makes its usefulness questionable.

Restricted access

Dose–Response Effect of an Inertia Flywheel Postactivation Performance Enhancement Protocol on Countermovement Jump Performance

Keegan B. Hall, Maarten A. Immink, David T. Martin, Hunter Bennett, and Robert G. Crowther

The purpose of this study was to investigate the dose–response effect of a high-load, 6-repetition, maximum effort inertial flywheel (IFw) squat postactivation performance enhancement (PAPE) protocol on countermovement jump (CMJ) performance metrics. Thirteen subjects completed 5 squat testing sessions: 1 session to determine back-squat 6-repetition maximum, 1 session to determine 6-repetition maximum IFw load, and 3 sessions to investigate the dose–response effect of an IFw PAPE protocol set at the load determined in the second session. In the IFw PAPE sessions, subjects completed either 1, 2, or 3 sets of IFw squats, then performed 5 CMJs over 12 minutes (1, 3, 6, 9, and 12 min post-IFw). All CMJ tests were conducted on a force platform where CMJ performance outcomes and impulse variables were calculated. There was no main time or volume effect for jump height, contact time, reactive strength index, peak force, or any of the impulse variables. A main time effect was identified for flight time (P = .006, effect size = 0.24) and peak power (P = .001, effect size = 0.28). The lack of change in jump height may indicate that too much fatigue was generated following this near-maximal IFw squat protocol, thereby reducing the PAPE effect.

Restricted access

Lower-Extremity Energetic Distribution During Rate-Controlled Ballet Jumps (Sautés) in Healthy Dancers

Amanda C. Yamaguchi, Lindsey H. Trejo, Hai-Jung Steffi Shih, David Ortiz-Weissberg, and Kornelia Kulig

Dancers frequently perform jumps in the context of a prolonged, continuous dance piece. The purpose of this study is to explore the lower-extremity energetics in healthy dancers performing repetitive dance jumps (sautés) before and after typical dance-specific choreography. Lower-extremity kinetic data were collected from 14 healthy female dancers during a series of sautés performed before and after 3 minutes of dance. Percent contributions of the lower-extremity joints to the whole-limb mechanical energy expenditure during ground contact were calculated. The jumps performed at the beginning were compared with the jumps at the end of the dance choreography. Dancers maintained the jump rate and consistent whole-limb mechanical energy expenditure between the jump series. As expected, for both jump series, the sautés had greater relative energetic contribution from the ankle and knee as compared with lesser contribution from the hip and toe. However, we observed lesser contribution from the knee and greater contribution from the hip after a 3-minute dance. After performing typical dance choreography, the dancers demonstrated a distal to proximal redistribution of individual joints’ contribution to whole-limb mechanical energy expenditure.

Restricted access

Impaired Neuromotor Control During Gait in Concussed Adolescents—A Frequency Analysis

Divya Jain, Valentina Graci, Megan E. Beam, Christina L. Master, Laura A. Prosser, Catherine C. McDonald, and Kristy B. Arbogast

Disruptions in gait function are common after concussion in adolescents; however, the neuromotor control deficits driving these gait disruptions are not well known. Fifteen concussed (age mean [SD]): 17.4 [0.6], 13 females, days since injury: 26.3 [9.9]) and 17 uninjured (age: 18.0 [0.7], 10 females) adolescents completed 3 trials each of single-task gait and dual-task gait (DT). During DT, participants simultaneously walked while completing a serial subtraction task. Gait metrics and variability in instantaneous mean frequency in lower extremity muscles were captured by inertial sensors and surface electromyography, respectively. A 2-way analysis of covariance was used to compare gait metrics across groups and conditions. Functional principal components analysis was used to identify regions of variability in instantaneous mean frequency curves. Functional principal component scores were compared across groups using a Welch statistic. Both groups displayed worse performance on gait metrics during DT condition compared to single-task, with no differences between groups (P < .001). Concussed adolescents displayed significantly greater instantaneous mean frequency, indicated by functional principal component 1, in the tibialis anterior, biceps femoris, and semitendinosus (P < .05) during single-task and DT compared with uninjured adolescents. Our observations suggest that concussed adolescents display inefficient motor unit recruitment lasting longer than 2 weeks following injury, regardless of the addition of a secondary task.

Restricted access

Volume 39 (2023): Issue 6 (Dec 2023)

Restricted access

The Biomechanics Research and Innovation Challenge: Development, Implementation, Uptake, and Reflections on the Inaugural Program

Celeste E. Coltman, Martina Barzan, Manuela Besomi, Victoria Brackley, Jaquelin A. Bousie, Julie Choisne, Laura E. Diamond, Taylor J.M. Dick, Nicole D’Souza, Samantha Fien, Alycia Fong Yan, Sheridan A. Gho, Alexandra Giraldo-Pedroza, Laura A. Hutchinson, Laura V. Hutchison, Crystal O. Kean, Maddison M. Kirk, Amy Lewis, Jayishini N. Maharaj, Nina Maher, Kerry J. Mann, Suzanne Martin, Karen J. Mickle, Azadeh Nasseri, Isobel H. Oon, Rory Purdie, Shayan L. Quinlan, Ceridwen R. Radcliffe, Suzanne J. Snodgrass, Siddharth Verma, and Michelle Hall

Biomechanics as a discipline is ideally placed to increase awareness and participation of girls and women in science, technology, engineering, and mathematics. A nationwide Biomechanics and Research Innovation Challenge (BRInC) centered on mentoring and role modeling was developed to engage high school girls (mentees) and early-mid-career women (mentors) in the field of biomechanics through the completion of a 100-day research and/or innovation project. This manuscript describes the development, implementation, and uptake of the inaugural BRInC program and synthesizes the research and innovation projects undertaken, providing a framework for adoption of this program within the global biomechanics community. Eighty-seven high school girls in years 9 and 10 (age range: 14–16 y) were mentored in teams (n = 17) by women in biomechanics (n = 24). Using a design thinking approach, teams generated solutions to biomechanics-based problem(s)/research question(s). Eight key reflections on program strengths, as well as areas for improvement and planned changes for future iterations of the BRInC program, are outlined. These key reflections highlight the innovation, impact, and scalability of the program; the importance of a program framework and effective communication tools; and implementation of strategies to sustain the program as well as the importance of diversity and building a sense of community.

Restricted access

The Combined Influence of Infant Carrying Method and Motherhood on Gait Mechanics

Kathryn L. Havens, Sarah Goldrod, and Erin M. Mannen

Postpartum mothers are susceptible to lumbopelvic pain which may be exacerbated by loading, like carrying their infant in arms and with baby carriers. Nulliparous women carrying infant mannequins may biomechanically mimic mother–infant dyad, but this has not been studied. The purpose of our study was to investigate biomechanical differences of 10 mothers carrying their infants and 10 nulliparous women carrying infant mannequins under 3 gait conditions: carrying nothing, carrying in arms, and carrying in a baby carrier (babywearing). Spatiotemporal gait parameters, peak ground reaction forces and impulses, and lower extremity and trunk kinematics were collected using motion capture and force plates and compared using a mixed 2 × 3 (parity × condition) analysis of variance (α ≤ .05). The largest differences occurred between carrying conditions: carrying in arms or babywearing increased vertical and anteroposterior ground reaction forces, trunk extension, ankle dorsiflexion, and hip and knee flexion. Kinematic differences were identified between arms and babywearing conditions. Together this suggests alterations in joint loading for both groups. Our study also contributes a novel understanding of postpartum health by demonstrating alterations in step time, anterior forces, and ankle and knee mechanics, suggesting that during gait, mothers carrying their own infants choose different propulsive strategies than nulliparous women carrying mannequins.