Eccentric cycling serves a useful exercise modality in clinical, research, and sport training settings. However, several constraints can make it difficult to use commercially available eccentric cycle ergometers. In this technical note, we describe the process by which we built an isokinetic eccentric cycle ergometer using exercise equipment modified with commonly available industrial parts. Specifically, we started with a used recumbent cycle ergometer and removed all the original parts leaving only the frame and seat. A 2.2 kW electric motor was attached to a transmission system that was then joined with the ergometer. The motor was controlled using a variable frequency drive, which allowed for control of a wide range of pedaling rates. The ergometer was also equipped with a power measurement device that quantified work, power, and pedaling rate and provided feedback to the individual performing the exercise. With these parts along with some custom fabrication, we were able to construct an isokinetic eccentric cycle ergometer suitable for research and training. This paper offers a guide for those individuals who plan to use eccentric cycle ergometry as an exercise modality and wish to construct their own ergometer.
Steven J. Elmer and James C. Martin
Jeffrey J. Martin, Laurie A. Malone, and James C. Hilyer
Research on elite female athletes with disabilities is extremely rare. Therefore, using the Sixteen Personality Factor Questionnaire (Cattell, Cattell, & Cattell, 1993) and Profile of Mood States (Droppleman, Lorr, & McNair, 1992), we examined differences between the top 12 athletes comprising the gold medal winning 2004 USA women’s Paralympic basketball team and 13 athletes attending the selection camp who did not make the team. Multivariate analysis of variance with follow-up tests revealed that athletes who made the Paralympic team scored higher on tough-mindedness (M = 5.7 vs. 4.3) and lower in anxiety (M = 5.6 vs. 7.8). For mood state, the Paralympians scored higher in vigor (M = 19.5 vs. 14.8) and lower in depressed mood (M = 3.9 vs. 6.7) and confusion (M = 5.5 vs. 7.5). The effect sizes were large (e.g., Cohen’s d = 0.91 - 1.69) for all five results.
Steven J. Elmer, John McDaniel, and James C. Martin
One-legged cycling has served as a valuable research tool and as a training and rehabilitation modality. Biomechanics of onelegged cycling are unnatural because the individual must actively lift the leg during flexion, which can be difficult to coordinate and cause premature fatigue. We compared ankle, knee, and hip biomechanics between two-legged, one-legged, and counterweighted (11.64 kg) one-legged cycling. Ten cyclists performed two-legged (240 W), one-legged (120 W), and counterweighted one-legged (120 W) cycling (80 rpm). Pedal forces and limb kinematics were recorded to determine work during extension and flexion. During counterweighted one-legged cycling relative ankle dorsiflexion, knee flexion, and hip flexion work were less than one-legged but greater than two-legged cycling (all P < .05). Relative ankle plantar flexion and hip extension work for counterweighted one-legged cycling were greater than one-legged but less than two-legged cycling (all P < .05). Relative knee extension work did not differ across conditions. Counterweighted one-legged cycling reduced but did not eliminate differences in joint flexion and extension actions between one- and two-legged cycling. Even with these differences, counterweighted one-legged cycling seemed to have advantages over one-legged cycling. These results, along with previous work highlighting physiological characteristics and training adaptations to counterweighted one-legged cycling, demonstrate that this exercise is a viable alternative to one-legged cycling.
James C. Martin, Christopher J. Davidson, and Eric R. Pardyjak
Sprint-cycling performance is paramount to competitive success in over half the world-championship and Olympic races in the sport of cycling. This review examines the current knowledge behind the interaction of propulsive and resistive forces that determine sprint performance. Because of recent innovation in field power-measuring devices, actual data from both elite track- and road-cycling sprint performances provide additional insight into key performance determinants and allow for the construction of complex models of sprint-cycling performance suitable for forward integration. Modeling of various strategic scenarios using a variety of field and laboratory data can highlight the relative value for certain tactically driven choices during competition.
Chee-Hoi Leong, Steven J. Elmer, and James C. Martin
Noncircular chainrings could increase cycling power by prolonging the powerful leg extension/flexion phases, and curtailing the low-power transition phases. We compared maximal cycling power-pedaling rate relationships, and joint-specific kinematics and powers across 3 chainring eccentricities (CON = 1.0; LOWecc = 1.13; HIGHecc = 1.24). Part I: Thirteen cyclists performed maximal inertial-load cycling under 3 chainring conditions. Maximum cycling power and optimal pedaling rate were determined. Part II: Ten cyclists performed maximal isokinetic cycling (120 rpm) under the same 3 chainring conditions. Pedal and joint-specific powers were determined using pedal forces and limb kinematics. Neither maximal cycling power nor optimal pedaling rate differed across chainring conditions (all p > .05). Peak ankle angular velocity for HIGHecc was less than CON (p < .05), while knee and hip angular velocities were unaffected. Self-selected ankle joint-center trajectory was more eccentric than HIGHecc with an opposite orientation that increased velocity during extension/flexion and reduced velocity during transitions. Joint-specific powers did not differ across chainring conditions, with a small increase in power absorbed during ankle dorsiflexion with HIGHecc. Multiple degrees of freedom in the leg, crank, and pedal system allowed cyclists to manipulate ankle angular velocity to maintain their preferred knee and hip actions, suggesting maximizing extension/flexion and minimizing transition phases may be counterproductive for maximal power.
Ernest G. Rimer, Linda R. Peterson, Andrew R. Coggan, and James C. Martin
Muscle-shortening velocity and hence power have been shown to increase in the presence of nitric oxide (NO). NO availability increases after consuming nitrate (NO3 -). Ingestion of NO3 -rich beetroot juice (BRJ) has increased muscle power in untrained adults.
This study determined whether NO3 - supplementation could acutely enhance maximal power in trained athletes.
In this double-blind, crossover study, 13 trained athletes performed maximal inertial-load cycling trials (3–4 s) immediately before (PRE) and after (POST) consuming either NO3 -rich (NO3) or NO3 -depleted (PLA) BRJ to assess acute changes (ie, within the same day) in maximal power (PMAX) and optimal pedaling rate (RPMopt). Participants also performed maximal isokinetic cycling (30 s) to assess performance differences after supplementation.
2 x 2 repeated-measures ANOVA indicated a greater increase in PMAX from PRE to POST NO3 (PRE 1160 ± 301 W to POST 1229 ± 317 W) than with PLA (PRE 1191 ± 298 W to POST 1213 ± 300 W) (P = .009; η p 2 = 0.45). A paired t-test verified a greater relative change in PMAX after NO3 (6.0% ± 2.6%) than with PLA (2.0% ± 3.8%) (P = .014; d = 1.21). RPMopt remained unchanged from PRE (123 ± 14 rpm) to POST PLA (122 ± 14 rpm) but increased from PRE (120 ± 14 rpm) to POST NO3 (127 ± 13 rpm) (P = .043; η p 2 = 0.30). There was no relative change in RPMopt after PLA (–0.3% ± 4.1%), but there was an increase after NO3 (6.5% ± 11.4%) (P = .049; d = 0.79). No differences were observed between the 30-s isokinetic trials.
Acute NO3 - supplementation can enhance maximal muscle power in trained athletes. These findings may particularly benefit power-sport athletes who perform brief explosive actions.
James C. Martin, Douglas L. Milliken, John E. Cobb, Kevin L. McFadden, and Andrew R. Coggan
This investigation sought to determine if cycling power could be accurately modeled. A mathematical model of cycling power was derived, and values for each model parameter were determined. A bicycle-mounted power measurement system was validated by comparison with a laboratory ergometer. Power was measured during road cycling, and the measured values were compared with the values predicted by the model. The measured values for power were highly correlated (R 2 = .97) with, and were not different than, the modeled values. The standard error between the modeled and measured power (2.7 W) was very small. The model was also used to estimate the effects of changes in several model parameters on cycling velocity. Over the range of parameter values evaluated, velocity varied linearly (R 2 > .99). The results demonstrated that cycling power can be accurately predicted by a mathematical model.
James C. Martin, Steven J. Elmer, Robert D. Horscroft, Nicholas A.T. Brown, and Barry B. Shultz
The purpose of this study was to develop and evaluate an alternative method for determining the position of the anterior superior iliac spine (ASIS) during cycling. The approach used in this study employed an instrumented spatial linkage (ISL) system to determine the position of the ASIS in the parasagittal plane. A two-segment ISL constructed using aluminum segments, bearings, and digital encoders was tested statically against a calibration plate and dynamically against a video-based motion capture system. Four well-trained cyclists provided data at three pedaling rates. Statically, the ISL had a mean horizontal error of 0.03 ± 0.21 mm and a mean vertical error of −0.13 ± 0.59 mm. Compared with the video-based motion capture system, the agreement of the location of the ASIS had a mean error of 0.30 ± 0.55 mm for the horizontal dimension and −0.27 ± 0.60 mm for the vertical dimension. The ISL system is a cost-effective, accurate, and valid measure for two-dimensional kinematic data within a range of motion typical for cycling.
John McDaniel, N. Scott Behjani, Steven J. Elmer, Nicholas A.T. Brown, and James C. Martin
Previous authors have reported power-pedaling rate relationships for maximal cycling. However, the joint-specific power-pedaling rate relationships that contribute to pedal power have not been reported. We determined absolute and relative contributions of joint-specific powers to pedal power across a range of pedaling rates during maximal cycling. Ten cyclists performed maximal 3 s cycling trials at 60, 90, 120, 150, and 180 rpm. Joint-specific powers were averaged over complete pedal cycles, and extension and flexion actions. Effects of pedaling rate on relative joint-specific power, velocity, and excursion were assessed with regression analyses and repeated-measures ANOVA. Relative ankle plantar flexion power (25 to 8%; P = .01; R 2 = .90) decreased with increasing pedaling rate, whereas relative hip extension power (41 to 59%; P < .01; R 2 = .92) and knee flexion power (34 to 49%; P < .01; R 2 = .94) increased with increasing pedaling rate. Knee extension powers did not differ across pedaling rates. Ankle joint angular excursion decreased with increasing pedaling rate (48 to 20 deg) whereas hip joint excursion increased (42 to 48 deg). These results demonstrate that the often-reported quadratic power-pedaling rate relationship arises from combined effects of dissimilar joint-specific power-pedaling rate relationships. These dissimilar relationships are likely influenced by musculoskeletal constraints (ie, muscle architecture, morphology) and/or motor control strategies.
James C. Brown, Caron-Jayne Miller, Michael Posthumus, Martin P. Schwellnus, and Malcolm Collins
Endurance running performance is a multifactorial phenotype that is strongly associated with running economy. Sit and reach range of motion (SR ROM) is negatively associated with running economy, suggesting that reduced SR ROM is advantageous for endurance running performance. The COL5A1 gene has been associated with both endurance running performance and SR ROM in separate cohorts. The aim of this study was to investigate whether COL5A1 is associated with ultra-marathon running performance and whether this relationship could be partly explained by prerace SR ROM.
Seventy-two runners (52 male, 20 female) were recruited from the 56 km Two Oceans ultra-marathon and were assessed for prerace SR ROM. The cohort was genotyped for the COL5A1 BsfUI restriction fragment length polymorphism, and race times were collected after the event.
Participants with a TT genotype (341 ± 41 min, N = 21) completed the 56 km Two Oceans ultra-marathon significantly (P = 0.014) faster than participants with TC and CC genotypes (365 ± 39 min, N = 50). The COL5A1 genotype and age accounted for 19% of performance variance. When the cohort was divided into performance and flexibility quadrants, the T allele was significantly (P = 0.044) over-represented within the fast and inflexible quadrant.
The COL5A1 genotype was found to be significantly associated with performance in a 56 km ultra-endurance run. This study confirms previous findings and it furthers our understanding of the relationships among ROM, COL5A1, and endurance running performance. We continue to speculate that the COL5A1 gene alters muscle-tendon stiffness.