The purpose of this study was to quantify relative contributions of impact interface, muscle activity, and knee angle to the magnitudes of tibial and femoral accelerations occurring after external impacts. Impacts were initiated with a pneumatically driven impacter under the heels of four volunteers. Impact forces were quantified with a force sensor. Segmental accelerations were measured with bone mounted accelerometers. Experimental interventions were hard and soft shock interfaces, different knee angles (0°, 20°, 40° knee flexion), and muscular preactivation (0%, 30%, 60% of maximal voluntary contraction) of gastrocnemii, hamstrings, and quadriceps. Greater knee flexion led to lower impact forces and higher tibial accelerations. Increased muscular activation led to higher forces and lower tibial accelerations. The softer of the two shock interfaces under study reduced both parameters. The effects on accelerations and forces through the activation and knee angle changes were greater than the effect of interface variations. The hardness of the two shock interfaces explained less than 10% of the variance of accelerations and impact forces, whereas knee angle changes explained 25–29%, and preactivation changes explained 35–48% of the variances. It can be concluded that muscle force and knee joint angle have greater effects in comparison with interface hardness on the severity of shocks on the lower leg.
Wolfgang Potthast, Gert-Peter Brüggemann, Arne Lundberg, and Anton Arndt
Steffen Willwacher, Manuel König, Wolfgang Potthast, and Gert-Peter Brüggemann
Longitudinal midsole bending stiffness and elasticity are two critical features in the construction of running shoes. Stiff elastic materials (eg, carbon fiber) can be used to alter the midsole bending behavior. The purpose of this study was to investigate the effects of midsole stiffness and elasticity manipulation on metatarsophalangeal (MTP) joint mechanics during running in 19 male subjects at 3.5 m/s. Midsole bending stiffness and elasticity were modified by means of carbon fiber insoles of varying thickness. Stiffening the shoe structures around the MTP joint caused a shift of the point of force application toward the front edge of the shoe-ground interface. Negative work was significantly reduced for the stiffest shoe condition and at the same time a significant increase of positive work at the MTP joint was found. It seems plausible that the increase in positive work originates from the reutilization of elastic energy that was stored inside the passive elastic structures of the shoe and toe flexing muscle tendon units. Further, an increase in midsole longitudinal bending stiffness seems to alter the working conditions and mechanical power generation capacities of the MTP plantar flexing muscle tendon units by changing ground reaction force leverage and MTP angular velocity.
Steffen Willwacher, Wolfgang Potthast, Markus Konrad, and Gert-Peter Brüggemann
The purpose of this study was to investigate the effect of heel construction on ankle joint mechanics during the early stance phase of running. Kinematic and kinetic parameters (ankle joint angles, angular velocities and joint moments, lever arms of ground reaction force, triceps surae muscle tendon unit lengths, and rates of muscle tendon unit length change) were calculated from 19 male subjects running at 3.3 m/s in shoes with different heel constructions. Increasing heel height and posterior wedging amplified initial plantar flexion velocity and range. The potential for a muscle to control the movement of a joint depends upon its ability to produce joint moments. Runners in this study showed decreased external eversion moments and an increase in eversion range. Maximum eversion angles were not significantly affected by shoe conditions. Without considerable tendon prestretch, joint moment generation potentials of triceps surae and deep plantar flexors might be inhibited due to rapid plantar flexion based on the force–velocity relationship. It could be speculated that increasing ankle inversion at heel strike could be a strategy to keep maximum eversion angles inside an adequate range, if joint moment generation potentials of deep plantar flexors are inhibited due to rapid plantar flexion.
Hiroaki Hobara, Wolfgang Potthast, Ralf Müller, Yoshiyuki Kobayashi, Thijs A. Heldoorn, and Masaaki Mochimaru
The aim of this study was to develop a normative sample of step frequency and step length during maximal sprinting in amputee sprinters. We analyzed elite-level 100-m races of 255 amputees and 93 able-bodied sprinters, both men and women, from publicly-available Internet broadcasts. For each sprinter’s run, the average forward velocity, step frequency, and step length over the 100-m distance were analyzed by using the official record and number of steps in each race. The average forward velocity was greatest in able-bodied sprinters (10.04 ± 0.17 m/s), followed by bilateral transtibial (8.77 ± 0.27 m/s), unilateral transtibial (8.65 ± 0.30 m/s), and transfemoral amputee sprinters (7.65 ± 0.38 m/s) in men. Differences in velocity among 4 groups were associated with step length (able-bodied vs transtibial amputees) or both step frequency and step length (able-bodied vs transfemoral amputees). Although we also found that the velocity was greatest in able-bodied sprinters (9.10 ± 0.14 m/s), followed by unilateral transtibial (7.08 ± 0.26 m/s), bilateral transtibial (7.06 ± 0.48 m/s), and transfemoral amputee sprinters (5.92 ± 0.33 m/s) in women, the differences in the velocity among the groups were associated with both step frequency and step length. Current results suggest that spatiotemporal parameters during a 100-m race of amputee sprinters is varied by amputation levels and sex.
Gerda Strutzenberger, Adam Brazil, Timothy Exell, Hans von Lieres und Wilkau, John D. Davies, Steffen Willwacher, Johannes Funken, Ralf Müller, Kai Heinrich, Hermann Schwameder, Wolfgang Potthast, and Gareth Irwin
Context: In sprint events, the first 2 steps are used to accelerate the center of mass horizontally and vertically. Amputee athletes cannot actively generate energy with their running-specific prosthesis. It is likely that sprint acceleration mechanics, including step asymmetry, are altered compared with able-bodied athletes. Purpose : To investigate spatiotemporal and kinetic variables of amputee compared with able-bodied sprinters. Methods: Kinematic and kinetic data of the first and second stance were collected from 15 able-bodied and 7 amputee sprinters (2 unilateral transfemoral, 4 unilateral transtibial, and 1 bilateral transtibial) with a motion-capture system (250 Hz) and 2 force plates (1000 Hz). In addition, bilateral asymmetry was quantified and compared between groups. Results: Compared with able-bodied athletes, amputee athletes demonstrated significantly lower performance values for 5- and 10-m times. Step length, step velocity, and step frequency were decreased and contact times increased. Peak horizontal force and relative change of horizontal velocity were decreased in both stances. Peak vertical force and relative change of vertical velocity were lower for the amputee than the able-bodied group during the first stance but significantly higher during the second stance. During the first stance, able-bodied and amputee sprinters displayed a similar orientation of the ground-reaction-force vector, which became more vertically orientated in the amputee group during second stance. Amputee sprinters showed significantly greater asymmetry magnitudes for vertical force kinetics compared with able-bodietd athletes. Conclusion: A running-specific prosthesis does not replicate the function of the biological limb well in the early acceleration phase.