measurements and inverse dynamics analysis, respectively. Methods Paralympic Athlete A single wheelchair curler (sex: male, age: 39 y, total body mass: 87.9 kg) was recruited from the Canadian Paralympic Team. The athlete was a gold medalist at the 2014 Paralympic Games and 2013 World Wheelchair Curling
Brock Laschowski, Naser Mehrabi and John McPhee
Yoichi Iino and Takeji Kojima
This study investigated the validity of the top-down approach of inverse dynamics analysis in fast and large rotational movements of the trunk about three orthogonal axes of the pelvis for nine male collegiate students. The maximum angles of the upper trunk relative to the pelvis were approximately 47°, 49°, 32°, and 55° for lateral bending, flexion, extension, and axial rotation, respectively, with maximum angular velocities of 209°/s, 201°/s, 145°/s, and 288°/s, respectively. The pelvic moments about the axes during the movements were determined using the top-down and bottom-up approaches of inverse dynamics and compared between the two approaches. Three body segment inertial parameter sets were estimated using anthropometric data sets (Ae et al., Biomechanism 11, 1992; De Leva, J Biomech, 1996; Dumas et al., J Biomech, 2007). The root-mean-square errors of the moments and the absolute errors of the peaks of the moments were generally smaller than 10 N·m. The results suggest that the pelvic moment in motions involving fast and large trunk movements can be determined with a certain level of validity using the top-down approach in which the trunk is modeled as two or three rigid-link segments.
Franklin Camargo-Junior, Marko Ackermann, Jefferson F. Loss and Isabel C.N. Sacco
The aim of this study was to investigate the effect of errors in the location of the center of pressure (5 and 10 mm) on lower limb joint moment uncertainties at different gait velocities (1.0, 1.5, and 2.0 m/s). Our hypotheses were that the absolute joint moment uncertainties would be gradually reduced from distal to proximal joints and from higher to lower velocities. Joint moments of five healthy young adults were calculated by inverse dynamics using the bottom-up approach, depending on which estimate the uncertainty propagated. Results indicated that there is a linear relationship between errors in center of pressure and joint moment uncertainties. The absolute moment peak uncertainties expressed on the anatomic reference frames decreased from distal to proximal joints, confirming our first hypothesis, except for the abduction moments. There was an increase in moment uncertainty (up to 0.04 N m/kg for the 10 mm error in the center of pressure) from the lower to higher gait velocity, confirming our second hypothesis, although, once again, not for hip or knee abduction. Finally, depending on the plane of movement and the joint, relative uncertainties experienced variation (between 5 and 31%), and the knee joint moments were the most affected.
Steven A. Kautz, Richard R. Neptune and Felix E. Zajac
The target article presents a framework for coordination of one- and two-joint muscles in a variety of tasks. Static optimization analyses were performed that minimize muscle fatigue, and it is claimed that the predicted muscle forces account for essential features of EMG activity “qualitatively” well. However, static optimization analyses use the observed joint moments, which implicitly assumes that they minimize the total muscle fatigue of the task. We use a forward dynamics (i.e., relationship between muscle forces and the kinematics and kinetics of task performance) modeling approach to show that this assumption does not appear to be true in cycling (which was used as an example task in the target article). Our results challenge the hypothesized coordination framework and the underlying concept that general coordination principles for dynamic tasks can be elucidated using inverse-dynamics-based analyses.
Pascal Schütz, Renate List, Roland Zemp, Florian Schellenberg, William R. Taylor and Silvio Lorenzetti
The aim of this study was to quantify how step length and the front tibia angle influence joint angles and loading conditions during the split squat exercise. Eleven subjects performed split squats with an additional load of 25% body weight applied using a barbell. Each subject’s movements were recorded using a motion capture system, and the ground reaction force was measured under each foot. The joint angles and loading conditions were calculated using a cluster-based kinematic approach and inverse dynamics modeling respectively. Increases in the tibia angle resulted in a smaller range of motion (ROM) of the front knee and a larger ROM of the rear knee and hip. The external flexion moment in the front knee/hip and the external extension moment in the rear hip decreased as the tibia angle increased. The flexion moment in the rear knee increased as the tibia angle increased. The load distribution between the legs changed < 25% when split squat execution was varied. Our results describing the changes in joint angles and the resulting differences in the moments of the knee and hip will allow coaches and therapists to adapt the split squat exercise to the individual motion and load demands of athletes.
Erik B. Simonsen, Morten B. Svendsen, Andreas Nørreslet, Henrik K. Baldvinsson, Thomas Heilskov-Hansen, Peter K. Larsen, Tine Alkjær and Marius Henriksen
The aim of the study was to investigate the distribution of net joint moments in the lower extremities during walking on high-heeled shoes compared with barefooted walking at identical speed. Fourteen female subjects walked at 4 km/h across three force platforms while they were filmed by five digital video cameras operating at 50 frames/second. Both barefooted walking and walking on high-heeled shoes (heel height: 9 cm) were recorded. Net joint moments were calculated by 3D inverse dynamics. EMG was recorded from eight leg muscles. The knee extensor moment peak in the first half of the stance phase was doubled when walking on high heels. The knee joint angle showed that high-heeled walking caused the subjects to flex the knee joint significantly more in the first half of the stance phase. In the frontal plane a significant increase was observed in the knee joint abductor moment and the hip joint abductor moment. Several EMG parameters increased significantly when walking on high-heels. The results indicate a large increase in bone-on-bone forces in the knee joint directly caused by the increased knee joint extensor moment during high-heeled walking, which may explain the observed higher incidence of osteoarthritis in the knee joint in women as compared with men.
Henrik Koblauch, Thomas Heilskov-Hansen, Tine Alkjær, Erik B. Simonsen and Marius Henriksen
It is unclear how rotations of the lower limb affect the knee joint compression forces during walking. Increases in the frontal plane knee moment have been reported when walking with internally rotated feet and a decrease when walking with externally rotated feet. The aim of this study was to investigate the knee joint compressive forces during walking with internal, external and normal foot rotation and to determine if the frontal plane knee joint moment is an adequate surrogate for the compression forces in the medial and lateral knee joint compartments under such gait modifications. Ten healthy males walked at a fixed speed of 4.5 km/h under three conditions: Normal walking, internally rotated and externally rotated. All gait trials were recorded by six infrared cameras. Net joint moments were calculated by 3D inverse dynamics. The results revealed that the medial knee joint compartment compression force increased during external foot rotation and the lateral knee joint compartment compression force increased during internal foot rotation. The increases in joint loads may be a result of increased knee flexion angles. Further, these data suggest that the frontal plane knee joint moment is not a valid surrogate measure for knee joint compression forces but rather indicates the medial-to-lateral load distribution.
D.G.E. Robertson, Jean-Marie J. Wilson and Taunya A. St. Pierre
The purpose of this research was to determine the functions of the gluteus maximus, biceps femoris, semitendinosus, rectus femoris, vastus lateralis, soleus, gastrocnemius, and tibialis anterior muscles about their associated joints during full (deep-knee) squats. Muscle function was determined from joint kinematics, inverse dynamics, electromyography, and muscle length changes. The subjects were six experienced, male weight lifters. Analyses revealed that the prime movers during ascent were the monoarticular gluteus maximus and vasti muscles (as exemplified by vastus lateralis) and to a lesser extent the soleus muscles. The biarticular muscles functioned mainly as stabilizers of the ankle, knee, and hip joints by working eccentrically to control descent or transferring energy among the segments during ascent. During the ascent phase, the hip extensor moments of force produced the largest powers followed by the ankle plantar flexors and then the knee extensors. The hip and knee extensors provided the initial bursts of power during ascent with the ankle extensors and especially a second burst from the hip extensors adding power during the latter half of the ascent.
Alan Hreljac, Rodney T. Imamura, Rafael F. Escamilla, W. Brent Edwards and Toran MacLeod
The primary purpose of this project was to examine whether lower extremity joint kinetic factors are related to the walk–run gait transition during human locomotion. Following determination of the preferred transition speed (PTS), each of the 16 subjects walked down a 25-m runway, and over a floor-mounted force platform at five speeds (70, 80, 90, 100, and 110% of the PTS), and ran over the force platform at three speeds (80, 100, and 120% of the PTS) while being videotaped (240 Hz) from the right sagittal plane. Two-dimensional kinematic data were synchronized with ground reaction force data (960 Hz). After smoothing, ankle and knee joint moments and powers were calculated using standard inverse dynamics calculations. The maximum dorsiflexor moment was the only variable tested that increased as walking speed increased and then decreased when gait changed to a run at the PTS, meeting the criteria set to indicate that this variable influences the walk–run gait transition during human locomotion. This supports previous research suggesting that an important factor in changing gaits at the PTS is the prevention of undue stress in the dorsiflexor muscles.
Miriam Klous, Erich Müller and Hermann Schwameder
Limited data exists on knee biomechanics in alpine ski turns despite the high rate of injuries associated with this maneuver. The purpose of the current study was to compare knee joint loading between a carved and a skidded ski turn and between the inner and outer leg. Kinetic data were collected using Kistler mobile force plates. Kinematic data were collected with five synchronized, panning, tilting, and zooming cameras. Inertial properties of the segments were calculated using an extended version of the Yeadon model. Knee joint forces and moments were calculated using inverse dynamics analysis. The obtained results indicate that knee joint loading in carving is not consistently greater than knee joint loading in skidding. In addition, knee joint loading at the outer leg is not always greater than at the inner leg. Differentiation is required between forces and moments, the direction of the forces and moments, and the phase of the turn that is considered. Even though the authors believe that the analyzed turns are representative, results have to be interpreted with caution due to the small sample size.